3M M1500SS Betriebsanweisung PDF herunterladen (Seite 11)

3M™ MicroTouch™ Display M1500SS User Guide 11

3M Touch Systems, Inc. Proprietary Information

Document #19-258 Rev AG

CHAPTER 2

Setting Up Your M1500SS Display

This chapter describes how to set up and integrate your 3M

MicroTouch

M1500SS

Display into a touch application system. You need to complete the following tasks:

• Unpack the components

• Connect the video and power cables to your computer

• Power on the display and test your setup

• Install the MT 7 software then connect the sensor cable

• Calibrate the touch sensor

System Requirements

The M1500SS Display requires a personal computer (PC). This touch display will not

work with Apple Macintosh computers.

The requirements for your PC are as follows:

• Your PC must have an available RS-232 serial communication (COM) port or USB

port. You connect the touch sensor to this port.

• Your PC must have a video card and video driver already installed for the display. If

you need to install a video card or a video driver, refer to your computer

documentation for instructions.

• Your PC must have a unique interrupt request (IRQ) available to the touch sensor

COM port. The touch sensor cannot share an IRQ with another device.

When choosing your workspace, select a sturdy, level surface. Also, make sure you can

easily access the back of the touch display and the computer. Easy access helps ensure a

smooth setup of the touch display.

Note: Before setting up your M1500SS Display, refer to the Important Safety

Information section at the beginning of this document.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Keine Kommentare

3M M1500SS Betriebsanweisung Seite 11